Description .
Roll edge thickness: .4 to 3 mm
Strip edge thickness: 8 mm (15 mm possible with tool change on the multifunctional cutting unit)
Edge strip length: 13.78" minimum to unlimited
Panel thickness: 8 to 60 mm
Minimum part width: 60 mm
Minimum part length: 160 mm
Feed Speed: Variable from 32 to 59 ft/min
Servo Power Fence
Pre-milling station with (2) 2 KW 12,000 rpm motors, one counter-clockwise and one clockwise (max material removal - 3 mm)
On-board infeed magazine for fully automatic feeding of reels and strips from 0.3 to 15 mm
Automatic cutter for rolled material up to 3 mm
Glue station: hybrid Glu-Jet technology - glue application using a nozzle applicator for glue cartridges or all commercial pellet hot melts (pellet hopper required but not included)
Automatic rinsing function directly from the control panel
Heating time: About 3 minutes
Motorized pressure unit: 1-axis servo motor for edge thickness adjustment, large driven roller with (2) additional idler rollers
End Trim Unit: (2) 0.45 KW 9000 RPM motors, mounted with a unipoint spindle allowing quick change from 10 degree bevel to flush cut via a system of pneumatic change (PCS)
Upper/Lower Cutter Unit: (2) 0.65 KW 12,000 RPM motors, with (4) servo motor settings for flush, radius and bevel cuts (servo motors adjust the cutter motor and the sensing pads, the pneumatic movement in and out of the unit carriage)
Corner rounding/deburring unit: (2) 0.4 KW motors, for top/bottom deburring and corner rounding - radius, chamfer. Can be programmed for use as a second top/bottom trim unit. 4 servo motors for height adjustment control and to adjust the whole unit
Feed rates vary when using the rounding/corner deburring unit depending on material thickness
Profile scraper unit: With 3 mm radius tooling, motorized adjustment of horizontal copying wheels with (4) servos
Finishing scraper: flat knives scraping board/strip joint, with pneumatic engagement/disengagement via controller - includes 2 blow nozzles, 2 insert knives
Upper and lower polishing unit with (2) 0.09 KW 1440 RPM motors
Air requirement: 6 bar
Machine dimensions: 18'3" long x 4'3" wide x 5'6" high
Voltage: 230 volts three-phase