Customer’s parts are wood grille profiles, requiring trim to length and end profiles to be machined. Material will be laid onto an infeed metering system and automatically picked up by the counter profiled back-up blocks attached to the feed chain.
Maximum length capacity of 120″
Minimum machine length capacity of 6″, minimum part length 12″ Widths: ¾n; 7/Bn; 1-1/8″
Special 12″ chain beam lay-up area.
CENTER STOCK SUPPORT
Two center stock supports, non-marring surface. FEED HOPPER (HORIZONTAL BELTS)
Horizontal infeed accumulation/inspection belts convey parts to the automatic metering system. Single or multiple piece feeding through adjustable accumulation stops.
FIRST STATION TRIMS
Two 10 HP 3600 RPM TEFC Mereen-Johnson tilting trim motors, worm and gear tilting, spindles 1-1/4″ dia. x 1/8″ of tooling space, assorted spacers, 4″ dia. collar and nut. Electronic scales with LCD readouts on vertical, horizontal, and tilt axes. Motors to trim below, using 10″ min. 12″ max. dia. tooling. Tooling is not included.
SECOND STATION HIGH SPEED COPES
Two 10 HP TEFC 3600 RPM commercial motors, driving Mereen-Johnson precision quill assemblies to 9000 RPM. Spindle RPM controlled through variable speed inverter. Spindles 1-1/4″ dia. unthreaded with 12 “Top-Lock sleeves and one high pressure grease gun per side. Electronic scales with LCD readouts on vertical and horizontal axes. Pneumatic quick change dust hoods. Cutting from below, against the feed.
1 HP AC motor, with two speed adjust, single screw, on THK rails. LH adjustable chain beam. Traverse setting system on the master control console through Panel View with position readout to the third decimal place (00.000″).
3 HP TEFC Euro Drive, with variable frequency adjust, safety brake, feed rate 15′ to 75′ per minute. Safety overload feed drive.
Special 42 pitch chain beams. 1-3/4″ wide by 5″ pitch MULTI-VEE feed chains, 8 tooth sprockets, detachable snap-in feed lugs with backup blocks on 5″ centers. “Ceram-P” chainways.
Special shortened hold down beams. Non-Marring PET belt-type hold downs on dovetail slides with single point vertical adjustment, scale and pointer reference. Overthickness feed stop safety limit switches mounted on infeed of hold down beams.
Single mounted machined angle stock guide with single point handwheel adjust, scale and pointer reference and position locks.
Motor mounted dust hoods provided for each motor station. pneumatic quick change dust hoods at the H. S. Cope
Combination PB/starter cabinet RH side, cabinet with safety door interlock, across-the line integral starters. One portable control for feed drive start-stop-jog controls provided on left hand infeed end of machine. Cable type E-stops infeed and outfeed. Trim motors interlocked to the feed drive. Trims must be on for feed drive to operate. Panel view in lieu of push buttons.
Telemecanique integral starters provided with overload protection.
All motors arranged for 3 phase, 60 Hertz, 230/ 460 volt power supply with 110 volt control circuits. Include starters sized for 3/60/230 volt. Main disconnect switch not included.
Safety anti-kickback shields and heavy serrated urethane flaps included on each side of machine.
Electrical Cabinets: Hoods and Guards: